CNC SHIELD VERSION-3

රු550.00

CNC Shield version-3
GRBL 0.9 compatible. (Open source firmware that runs on an Arduino UNO that turns G-code commands into stepper signals
4-Axis support (X, Y, Z, A-Can duplicate X, Y,Z or do a full 4th axis with custom firmware using pins D12 and D13)
2 x End stops for each axis (6 in total)
Coolant enable
Uses removable Pololu A4988 compatible stepper drivers. (A4988, DRV8825, and others)(Not Included)
Jumpers to set the Micro-Stepping for the stepper drivers. (Some drivers like the DRV8825 can do up to 1/32 micro-stepping )
Compact design.
Stepper Motors can be connected with 4 pin Molex connectors or soldered in place.
Runs on 12-36V DC. (At the moment only the Pololu DRV8825 drivers can handle up to 36V so please consider the operation voltage when powering the board.)

In stock

Category:

Reviews

There are no reviews yet.

Be the first to review “CNC SHIELD VERSION-3”

Vendor Information

  • Store Name: Jinadasa Electronic And Electrical Stores
  • Vendor: Jinadasa Electronic And Electrical Stores
  • Address: No-F14, Main Bus Stand Complex
    Kaduwela
    Kaduwela
    10654
  • 4.50 rating from 8 reviews
Hogwa.lk cart
There are no products in the cart!
Continue shopping
0